2 x 2 pezzi NRF24L01+ 2,4 GHz Wireless Transceiver Module For Arduino Microcontroller Upgraded Version for NRF24L01

DESCRIZIONE:

This NRF24L01+ Wireless Transceiver Module is an easy and suitable module if you want to setup your wireless communication system with low cost!! This module can achieve a good balance between wireless transition performance and cost! You can easily add it with your own MCU/ARM/PIC/AVR/STM32 system!

Caratteristiche

2 Mbit/s, 1 Mbit/s, 250 Kbit/s, tre selectable transmission rate.
MultiCeiver hardware e sei funzioni di ricezione.
2 Mb/s rendono VoIP di alta qualità.
+/- 60 ppm crystal.
Richiede solo un induttore esterno in corrispondenza dell'antenna
There is no need multi-layer PCB.
5 V tolerance level inputs.
Improved ShockBurst and the serial interface can be easy to connect with a variety of low-cost MCU.
There se no need SPI interface with the MCU.
Received in the rate of 2Mbit/s, the peak corrente is 12.5mA.
Quando la rate di 2 Mbit/s @ 0dBm output, the peak corrente is 11mA.
Modalità Power-down, power consumption is 400nA.
Standby mode, power consumption is 32uA.
130us fast switching and wake time.
Con tensione regolator:Oltage regulators on board.
Antenna integrata 2,4 GHz, supporto fino a sei canali di ricezione dati.
Tensione di funzionamento: 1,9-3,6 V.
Small Taglia:15*29mm

Contenuto della confezione:
2 x NRF24L01+ Wireless Transceiver Module