X Max - Kit di 3 testine di stampa estrusore per stampante 3D Qidi X Max 3/X Plus, kit hotend aggiornato per Qidi X Plus Hot End in acciaio temprato (1 set kit hotend (silicone termico))

This is a very small, lightweight hot-end compared to the original. That will be a slight weight advantage for the extruder mass math, so re-run the calibrations to take into account any changes your input shaping can take advantage of.The heat block is small, and the small ceramic heater is clamped to one side. I see similar heaters on the Bambu a1, so it might be ok, but it does not look as nice as a stock hot end with the round ceramic heaters, but it could be fine, I will have to see how it does on those long prints.It seems like a quality build. The small nozzle is very low mass, which could be an advantage.The hot end is only partially assembled, and came with no instructions, but there is only one way for the parts to go together, but that doesn't guarantee success. It looks like miniature hot-end, it will not be trading nozzles with your existing hot-ends, as they are unlikely able to be the same size.However the length and attachment points are a fit for my Qidi X-max3.

There is no way on earth this will fit any of the devices they have listed. Not only that, but when they say “upgrade” I think they must think it means something completely else. The nozzle doesn’t even extend far enough for it to be able to place filament on the build plate without the sensor touching the plate. Also, look at the size difference, the one I’m holding is the original. The nozzles aren’t even compatible with this?