I was looking for a basic HDMI splitter to use with my cable box signal. I wanted to split my set top box to four different devices and this splitter did just that.What I liked about this splitter is the dark metal housing, it hides well within the shelf. I also liked that all cables are located in the back of the unit including the USB C power cable. It makes hiding cables more easier when they don’t come out of all sides of the device. Another nice feature was that the LED lights are on the top instead of pointing forward towards you. My other splitter would practically blind you at night because the lights were facing outwards. The lights also have a dim or bright setting based on which HDMI port is active and what is not. The USB C power is a nice standard now when it comes to power supplies that you can plug it into a simple USB hub.The splitter doesn’t seem to get overly hot and so far has done a great job splitting my TV signal to multiple screens. Since I’m really only using it at 1080p 30fps, it works well for my needs. So far I’ve had no issues with audio, video or sync issues. I’m quite happy with this 1 in 4 out HDMI splitter.

Mithin der beste Splitter, den ich bisher verwendet habe. Er wird auch mit mehreren Geräten sofort erkannt und das Upscaling verursacht keine Aussetzer, was bei ähnlichen Geräten oftmals zu beobachten ist.Die angegeben Auflösungen werden allesamt erreicht, und sogar beim booten wird das BIOS beim PC angezeigt.Sehr zu empfehlen!

Attention ceci n'est pas un Switch comme je le pensais il s'agit d'un répartiteur qui permet de mettre la console par exemple sur un côté (input) et de répartir le flux (si on regarde la télé Netfl... ou autre) sur plusieurs sorties du genre une télé chambre, une salon et un écran d'ordinateur. Regarder le même film sur plusieurs écrans différents soit plusieurs pièces différentes, chacun devant mais pour le même flux.Fonctionne bien. Me sert peu mais de temps en temps pour regarder un flux télé à plusieurs dans des pièces différentes.

🔍 PRIMA IMPRESSIONE:Arrivato all’interno di una confezione che non presenta il contenuto, si tratta di uno splitter HDMI per duplicare lo stesso contenuto su più monitor, e per la precisione fino a 4 schemi 4K a 60Hz.Molto veloce e pratico da usare, basta collegare i monitor e poi il cavo di alimentazione (non l'alimentatore) usb a corredo per avere subito il segnale in uscita.Ricordo inoltre che in aggiunta la video, portando il segnale HDMI, porta anche l’audio di qualità digitale su un solo cavo.Utilizzato nel mio studio per avere due monitor sempre connessi e ampliare quindi la mia area di lavoro visiva.✅ ASPETTI POSITIVI:• Buona fattura• Buoni materiali• Ottimo per ufficio e scrivanie dove è richiesto tanto spazio visivo di lavoro❌ ASPETTI NEGATIVI:• Nessuno📝 CONCLUSIONI:ora che tutti i segnali video passano per lo standard HDMI, trovo questo oggettino molto pratico e funzionale per i miei due monitor da 27”.Non avendo neppure bisogno di driver o configurazioni particolari, lo trovo molto utileGiusto il prezzo per la qualità offerta per cui per me, acquisto consigliato!

This is the exact product I was needing after a recent refurb. I decided I wanted the room layout differently and to permanently fix a projector actually running on its own HDMI but was met with a headache. I do a lot of reviews for projectors and generally use a long feed, now I can have it permanently fixed with the new layout.Previously I just ran cables around the edge and swapped HDMIs as and when needed from devices and would line out for sound to the Receiver.I wasn't sure if this would function as I wanted, I already split from my Sky Q UHD box to two 4k TVs and ran back on the main TVs arc to my Denon with a two ways. One is an Oled in the main room and the other split is to a Qled in the dining room, the projector I'm using is 1080p at the moment, so I needed at least a three way split and downscaling to 1080p.This doesn't have a single button and I was slightly apprehensive about this as others need a manual downscale flick but it's actually fantastic! Everything is automatically done. So my two mains get 4k and the third is 1080p for my projector. I can have all devices on at the same time without issues too and the 4k remains stable, no lag and zero reduction in image.I note someone else mentioned banding occuring but I had full HD with the image identically duplicated.Another issue was it being HDMI 2.0 but Sky Q uses 1.4, so the bandwidth limit is actually higher than the signal they need.You'll see it in my TV unit wired up! I have Sky Q going into the in HDMI and then two out to the TVs and third to the projector.I was able to connect a fourth cable to the forth HDMI out and have this directly into my AV Receiver allowing surround when using the projector too! It allows me to send Atmos on the fourth as it's not reliant on both image and sound bottlenecking.Normally you wouldn't be able to get audio without having the TV on obviously and wouldn't have the TV on when projecting, so I'm over the moon the forth port allowed me to send directly like this.The power source is a USB to USB C cable and can be run directly from a 5w port or from a USB plug and any standard USB C cable.

No necesita configuración ya que es totalmente automático. Tan solo necesitamos conectarle su cable USB Tipo-C de alimentación para darle corriente, (no trae adaptador de enchufe pero sí el cable USB).Sirve para conectar una videoconsola, un PC, decodificador de TV, cualquier TVBox o Fire TV Stick y ver en hasta 4 pantallas a la vez la misma señal. Básicamente es un dispositivo muy sencillo que lo único que hace es repartir la señal de audio-video de cualquier fuente HDMI en 4 salidas a la vez. Como tiene función de escalado automático (EDID) en cada pantalla vamos a poder visualizar la mejor resolución, tasa de refresco y calidad de imagen posible en cada pantalla independiente. Por ejemplo, en una pantalla 4K ver nuestra señal HDMI en resolución 4K mientras que en otra pantalla que solo acepta 1080p verlo en 1080p. Acepta resoluciones y tasas de refresco altas como 4K a 60Hz - 50Hz - 30Hz - 24Hz. También resoluciones bajas 1080p, 720p, 576i y 480i, y video 3D, HDR y codecs de audio DTS y Dolby.Me ha parecido sin duda un dispositivo muy cómodo, facil de instalar y funcional. Lo recomiendo.

Il prodotto è davvero utile se vuoi duplicare lo stesso contenuto su 4 schermi in 4K a 60Hz. Perfetto per chi ha bisogno di una soluzione semplice e veloce, senza compromettere la qualità video o audio. I LED ti mostrano chiaramente quali porte sono attive, ed è compatibile con tanti dispositivi. Se cerchi un modo facile per vedere lo stesso contenuto su più monitor, questo splitter fa esattamente quello che promette!