è vuoto
è vuoto Esempi di utilizzo:
Stihl:
009, 010, 011, 017, 018, 019, 021, 023, 025, E160, E180, ms190, mS200.
VAUQUELIN sylvie
Recensito in Francia il 4 dicembre 2024
Finition à revoir la chaîne ne coulissent pas mauvais
Cliente
Recensito in Italia il 9 novembre 2023
In linea con le specifiche
cappelle
Recensito in Francia il 8 dicembre 2022
Très bon rapport qualité prix il vaut largement une certaine marque comme S….
Ralf Tams
Recensito in Germania il 26 aprile 2021
alles bestens
Lima484
Recensito negli Stati Uniti il 16 novembre 2020
Exact fit for a Stihl MS170 with .043" PMM3 chain. Well made. Fast delivery. About half the cost of the Stihl bar, which my Stihl dealer didn't have in stock, anyway
Ron G.
Recensito negli Stati Uniti il 7 ottobre 2018
I purchased this bar for my Stihl 192T primarily because it was half the price of the Stihl bar. I could not get a chain to go into the bar groove. In measuring the groove, I found that it varied between .030" and .0375". (not the proper .043") After 1/2 hour of scraping the paint from inside the groove I could force a chain onto the bar. I installed it & fired up my saw. The chain would not move. The only result was Smoke billowing from the clutch. I removed the bar & chain & spent another 1/2 hour with a scraper, file and sandpaper removing paint from the groove. Reassembled the bar & chain & fired up the saw. The chain actually moved this time (albeit slowly). After about 10 to 12 seconds at full throttle the chain sped up somewhat, but I still got quite a bit of smoke. I again disassembled the bar & chain, (finding them both to be very hot) and resumed cleaning out the groove. A half hour later, I could get the chain to slide in the bar by hand. Reassembled everything & fired up the saw with the oldest, most worn chain I could find. The chain appeared to move much more freely, but stopped instantly when I let off the throttle. 15 seconds at full throttle still heated the bar & chain to the point where they could not be touched with a bare hand.Two lessons learned from this experience were: 1.) Powder coat is tough as hell. 2.) A bargain is not worth the $$ saved if it requires hours of modification to achieve a half way mode of acceptance. I'll use this bar (in 15 to 20 second bursts) & continue to work on it in the hope that it will some day "wear in". Thankfully I have other saws to use until then!
Prodotti consigliati
Potrebbe piacerti anche