Navisafe 767 canotto Completo Set

Easy install... very good product!

Excellent product. Good quality and very versatile. When I anchored my trawler with the mast down I realized that I nad no anchor light. I zip tied the stern light of this kit on the fly bridge, set it on the mode with four white leds at each point and it was the perfect emergency anchor light.

As described and quick delivery. Thank you

These are really well-built lights and mounts... I went through two $60 clamp on lights before dropping the money for my 9.5' AB RIB I use as a tender. The lights have multiple modes that allow you to avoid blinding yourself by setting the angles of the on lights. Mounts both attach very well and is the only one so far to have an effective front light solution that I have found.

The only reason I'm not giving 5 stars is because the mount for the 360 white light isn't great, its only a half solution. The mount is well made and the locking mechanism is solid but it really on supports the bottom end of the pole while providing no lateral stability. I mounted it as low as possible on the inside of my Achilles transom and then added a 3/4 inch PVC pipe clamp (the O.D. of 3/4" PVC is 1 inch) as high up as possible, there is about 8 to 10 inches of separation between the two. Even with that two point support the plastic pole, although beefy by plastic standards, shakes pretty bad even at slow speeds. I took one section of the pole out to make it shorter which helps some, but then the level of the light is just barley above my outboard. I would recommend that anyone using this on an engine driven inflatable to keep a dead slow speed (as you should at night) because I'm afraid it would break off otherwise. The lights themselves are great, very bright. I wish the 360 white light was made so that I could mount it on a 3 foot section one inch stainless tube, then I would have no worries about it breaking.Some people complain about the front mount not sticking and staying on... That's because they don't know how to properly clean and work with adhesives on inflatable boat materials. PVC material needs to be cleaned with MEK and Hypalon with Toluene. The boats needs to be inflated to correct pressure and it helps if the material is warm. The 3M VHB tape (very high bond) should also be warmed in the sun, with a hair dryer, or very low with a heat gun. Because I have a large D ring on the inside of my bow at center and the big handle on the outside of the bow I was able to attach a ratchet strap to apply some pressure and left it that way for 24 hours. I got excellent adhesion and no issues so far after folding up the boat several times.