Carrello

è vuoto

è vuoto
Disponibile

Modulo GPS USB Antenna Supporta GPS+GLONASS Beidou Built-in Flash per Arduino Pixhawk IPEX compatibile, meglio di VK-162

Spedizione gratuita per ordini superiori a 25,99€
20,99€ -52%

9,99€

Informazioni su questo articolo

  • Supporta GPS+GLONASS (predefinito); GPS+Beidou; GLONASS+ BeiDou molteplici modalità Amplificatore di segnale LNA incorporato
  • Flash incorporato, velocità di trasmissione del prodotto di configurazione libera, dichiarazione di uscita, velocità di uscita, secondo impulso e altri parametri
  • Condensatori TCXO Crystal e Farad integrati per un avvio più rapido
  • Impossibile visualizzare il collegamento alla documentazione del prodotto. Se hai bisogno di documentazione tecnica, fai clic su "Geekstory", fai clic su "Fai una domanda" per inviarci un'e-mail
  • Documentazione che puoi trovare in fondo alla pagina dei dettagli - Guide e documenti sui prodotti: (Manuale utente (PDF), che contiene dettagli su come utilizzare e collegamenti ai driver.


Descrizione del prodotto:
Dimensioni: 28 x 48 x 8,5 mm.
Supporta GPS+GLONASS (predefinito); GPS+Beidou;
GLONASS+ BeiDou multiple mode Amplificatore di segnale LNA integrato
Flash incorporato, baud rate del prodotto di configurazione gratuita,
dichiarazione di uscita, velocità di uscita, secondo impulso e altri parametri
Condensatori TCXO Crystal e Farad integrati per un avvio a caldo più veloce
Frequenza di aggiornamento 1-10Hz
Frequenza: L1, 1575.42MHz
Baud rate: 4800, 9600, 19200, 38400, 57600, 112500bps.
Canali: 56
Sensibilità
Tracciamento: -164dBm Acquisizione: -159dBm Avviamento a freddo -147dBm
Avviamento a freddo: media 26 secondi
Avvio a caldo: Media 24 secondi
Avvio a caldo: media 1 secondo
Segnale timepulse: RMS 30 ns
L'altezza massima: 50000 metri
Velocità: 500 m/s
Accelerazione: 4 G.
Frequenza di aggiornamento: 1-10 Hz
Temperatura di funzionamento: da -40 °C a 85 °C.
Temperatura di stoccaggio: da -40°C a 85°C
La confezione include:
1 modulo GPS USB.


david1024
Recensito negli Stati Uniti il 3 maggio 2024
this shows up, out of the box, as /dev/ttyACM0 (thats a zero, not an O) on most Linuxes. And the accuracy is pretty bad with the internal antenna. however, it improves greatly with an external antenna. I'm not sure how it reconciles the difference between internal and external antenna locations, but I'm using it for time, not location. The silkscreen on the board is a bit misleading in that it has TXD/RXD when that's actually USB D+/D-. I removed the connector and had to do a double-take when I soldered on what needed to use and rechecked that it was USB an not rs232. I suppose there may be a mode for the chip where it can do either that is set at the factory.... lsusb shows it up nicely and you can watch in minicom with 115200/N81 if you like too. The PPS has a 10% duty cycle that matches the green LED flashing. once I get this project done, I may update this with position and timing jitter information.
M.
Recensito negli Stati Uniti il 21 agosto 2023
Using on my Pi and have had 0 issues getting it working and keeping it working. It has an LED that blinks green when its got a satellite lock that is very useful. Be aware - It's a little wider than standard USB devices and it partially covers the USB port next to it, making that port unusable. Simple solution is a 3" USB extender or a 90 degree right angle extender.
Don Marlin
Recensito in Canada il 9 dicembre 2022
This thing was maybe accurate to +/- 10 meters after sitting for a day.Pretty disappointing. Not recommending anyone buy this.
ur_a_buS
Recensito in Canada il 25 novembre 2022
Shielding wasn't properly soldered onto board and fell off. Poor manufacturing quality.
Demonsthenes
Recensito in Canada il 26 novembre 2020
As long as it works, which it does, it's good. Just try to keep it away from heat and EM noise sources!