Lee Precision 90139 Galga con Shell Holder Calibro 308 W, Multicolore, Taglia Unica

Perfetto

Ottimo pezzo di ricambi buon prezzo e arrivato velocemente

Arrived quickly, was exactly what I ordered and meets expectations

Ottimo compromesso per riportare a misura bossoli con poca spesa. Attenzione che per l'utilizzo necessita di ulteriore presso acquistabile a parte

Grazie tutto ok

ok

Funciona sin problema pero recomiendo ayudarse de un taladro si no se van a quedar sin dedos

Facile da usare

Semplice,piccolo,comodo.....in sintesi......grande.

As with all Lee Precision products it’s very well made and at a very competitive price. Should last years

Buono qualità prezzo...

Bien, mais QUE si tu veux soit vérifier soit réduire un douille a la MAX fixé par Lee. Pas d’alternatif. Si c’est le cas, facile, rapide et PAS de prob. Mais en Europe, on trouve beaucoup des douilles sont fabriques plus court que ce max, donc après plusieurs décharges resteront de longueurs variables, mais en-dessous de la limite max. Rien à faire la, sauf utiliser un autre outille. Mais BON pour rapide vérification des SUR-LONGUEURS après plusieurs tirs (et après decapp) si t’es afficionado de la longueur MAX inaltérable de Lee.

I'm loading on a progressive press and do all of my case prep on it. While waiting for a specific trim die, I needed something to get me going while my backorder was filled. This inexpensive little item fit the bill and worked pretty good. I will say this, I don't know how handloaders use only these to trim brass, even chucked in a drill.Here's the process for using this:1. Thread the stop pin into your Lee cutter all the way down2. Chuck the lock stud into your drill (faster the better IMO)3. Slide a casing into the lock stud and tighten4. Start the drill, and stick the cutter/pin into your casing until you no longer feel resistance5. Remove the casing and measureAll of my cases reliably trimmed down to a 2.007" measurement. Min is typically 2.005", so that's not too bad at all.It did take me forever to get 40 cases trimmed, and this thing does toss brass shavings everywhere, so wear eye protection and maybe even a glove on your trimmer hand to protect against brass splinters. But with no other options, and for less than $20, this got me by and did it accurately.