è vuoto
è vuotoKit imbuto di riempimento del liquido di raffreddamento senza fuoriuscita con interruttore, montaggio universale, kit imbuto di riempimento del radiatore applicabile a qualsiasi veicolo
JB3333
Recensito nel Regno Unito il 2 dicembre 2024
Impossibile caricare il contenuto multimediale.
Mark F
Recensito nel Regno Unito il 3 gennaio 2024
Great addition to my car tools and equipment.This will come in very useful in the future on various vehicles.It made the bleed process painless with no coolant spillages. Good value for money.
anthony darbon
Recensito nel Regno Unito il 4 aprile 2024
Used it on a Peugeot 207 and fit was good and easy to use gave me a hassle free water change
mark
Recensito nel Regno Unito il 31 luglio 2023
Worked a charm on a Subaru boxer engine known for air locks. Filled up via the top hose, then this funnel. Left the engine to fully cool down, at this point it drew some coolant back in (or contacted due to temperature change). No air locks, first time 😁There was not a single leak or drip anywhere. The seals are pressure fit, maybe people need to push the fittings together before doing the threads up? Doing the threads up first may not create the seal. Don't do it too tight as they are more difficult to undo than to tighten
MrHoboPie
Recensito nel Regno Unito il 6 novembre 2022
Took a gamble on the product as it had zero reviews but was fairly priced compared to other coolant funnel/reservoirs.MK1 MX5 radiator is difficult to "burp" free of air due to how low the cap sits. Ideally, it required something that would seal to the radiator but also allow me to remove it without dumping a litre of coolant over the engine bay.Stop cock worked well, the unit didn't leak and I finally filled the coolant loop without trapping air in no time at all.Word of advice - the manual is almost useless so I suggest you figure out the correct fittings by:First trying the radiator caps on your radiator ahead of timeThen create the cap seal by building an o-ring stack in this order:[orange plastic feed with smooth bore out, snug fit o-ring, radiator cap, 1 or 2 larger O-rings in the kit to take up the slack, then thread onto the funnel's black screw fitting.]Use as few elbows and joints as you can to reduce leak points/ flex.
Prodotti consigliati
Potrebbe piacerti anche