Même à moin de 30€ vous perdez votre argent.Axes fer sur fer aucun roulement à billes avec des jeux dans les axes impensables pour une guitare !Je vais utiliser que le châssis principal et le réusiner pour y joindre les axes et la tige d'un original B7 pour le passer en B5.Si vous n'êtes pas équipé passez votre chemin !

The head of One of the four screws got broken. Had to reinstall It from the start. Poor quality of the metal used... And the tremolo bar gets loose After minimal usage...

though i really like the looks of it. the rolling mechanism is very flawed. the spring is weak also

I've not fitted this trem yet, so can't comment on its operation. Based on first impressions out of the bag,however, this is a rather cheap and nasty product, made to very loose tolerances and in need of a fair bit of work to make it useable. The amount of lateral play on the part that holds the pins to which the ball ends are attached is ridiculous - 5-6mm. I fixed this by prising off one of the clips and fitting a thick rubber washer between the arm holder and the main body, which should do the job. The pins themselves protruded at a wild variety of angles, as if the holes for them had been drilled by a blind man! I have successfully managed to bend them back to some resemblance of conformity, but was terrifued of snapping them in the process. I can only hope they are still strong enough to hold the strings under tension.The other defect l found was the roughness of the plating, especially on the part of the arm where you would grab it...exactly the place where you don't want sharp edges! Fortunately l managed to rub this down and get it smooth without damaging the plating.So, not the best of items. I have fitted a couple of real Bigsbys in the past and itcwould be foolish to expect similar quality to a genuine Bigsby B6 costing ten times as much. So l suppose for £22 and half an hour's corrective work, its probably just about worth the money. The real test, of course, will come when l fit it to the guitar I'm still building.Three stars, because it looks the part, is inexpensive and with work, it should be useable.

Devo dire che non l'ho ancora montato ma sembra fatto davvero bene: cromato giusto, niente sbavature e pesantezza che trasmette senso di solidità. Grazie.

Brilliant cheap alternative to Bigsby12 X cheaperQuality is ok, but for price, can't complain

Confermo i problemi riscontrati da altri riguardo al bloccaggio della leva; io ho risolto con un controdado, ma su altra chitarra con ponte simile c'è un dado autobloccante - quindi il problema sarebbe facilmente risolvibile dalla fabbrica (per questo ho messo una stellina in meno) - comunque lo consiglio perché rispetto all'originale costa molto meno, funziona allo stesso modo, ed anche esteticamente si presenta bene.

Nicht schlecht - aber!Das Material, die Optik und Montage sind vollkommen in Ordnung. Habe es auf meine billige SG montiert. Die Feder ist zu hoch und ich habe sie gegen die kürzere eines echten Bigsbys getauscht. Jetzt stimmt mal die Höhe des Hebels. Der Hebel lockert sich, weil die Gussreste auf der Seite, wo die Mutter sitzt, nicht sauber entfernt sind. Deshalb blockiert die Rote Beilagscheibe und öffnet so die Mutter. Ich habe unter diese eine breite Metallbeilagscheibe gelegt, denn diese ist dann glatt und verbessert den Schleifeffekt, ohne die Mutter zu lösen.