Peaty's Kit di conversione ruote tubeless – Kit Enduro, DH, Gravel & Road Bike – Include: valvole tubeless, nastro adesivo e sacchetto sigillante per pneumatici in biofibra – Guida passo passo per la

This kit worked well except for the valve was a little wide for a 17 mm rim. A little sanding took care of that and no other issues with getting the kit to seal. Perhaps you should develop a kit size for a little smaller rim with assymetric valves instead of round. .

All you need to go tubeless.. easy.

I'm not satisfied with the adhesion of the tape: it peels off on overlapping layers and at the edges near the bead. I had to retape my rear rim three times because the Pirelli Pzero Race tire (definitely not the tightest one) pulls the tape off when popping onto the rim. The valves and sealant, however, are working fine.

This was my first time going tubeless, and I was perhaps a bit ambitious converting with brand new tyres that still had some kinks in the sidewall beading from where they'd been folded up. I was also converting 2.6" tyres, so they were quite "flappy and loose" when not inflated. I was using Peaty's CO2 cartridges for the initial tyre inflation. The instructions recommend inflating the tyre before adding the sealing fluid, but I could not get this to work after several attempts. When I added the sealing fluid and tried again the first tyre went up first time. The second tyre took three attempts (and I had to top up the sealing fluid as quite a lot had leaked out) but I got there in the end - I just had to wait ten minutes because I suspect the sealing fluid had frozen due to repeated attempts at CO2 inflation. The Peaty's kit and instructions were all spot on, and having seen a few youtube videos about tubeless conversion, I was braced for it to take a bit of time because I was using new tyres. Overall, the kit is great and with a little perseverance it got a compete novice converted to tubeless in about two hours.

Decided to take the tubeless plunge, so based on the really positive reviews of Peaty's Holeshot Sealant I've seen, I thought I'd give this kit a go.First off the packaging is really neat, so clearly explained and comes with everything you need to get the conversion done. They've clearly spent some time to get this just right, and having the QR images to take you through to the setup video's is super useful. Watching the installation instructions narrated by Steve Peat is pretty cool!!The instructions are so helpful and really makes for an easy installation. Everything was easy and based off this, I don't get why everyone complains about tubeless setup.The tape looks amazing on the rims too, I feel almost a bit bad having it hidden in the tyres. The valves look neat too, and having a lifetime warranty on them just adds confidence. Nice tought with the spoke tool and valve core remover in the caps.The tyres set up easy first time, and not had any pressure loss. I've not had a puncture that I know of yet, so I can't really comment on that aspect, but as a kit, it's just easy to use, great packaging and very well thought out. Good work Peaty's!