çok güzel çok kaliteli bir ürün yapan firmayı tebrik ederim

TL;DR - Will not look as nice as it is in the listing and caution should be used - explanation below.There are three panels to be mounted and the images on the listing shows them edge to edge with no gaps and the "BONTEC" logo. What makes this questionable is the panel is 16" with the five mounting holes being 15.5" from far left to far right so there is a 3.875" separation between the holes. The panels have no way to be joined together. What I have seen on tracked storage like this is if they are to be mounted where one track abuts another there is a metal back piece that fits inside the track between the two sections so that they support each other since putting two screws into wall board about an inch apart will weaken the wall board. The other benefits of the backing piece is that it ensures the two tracks are aligned and fills any visible gap in the track if the fit between are not perfect. The included mounting hardware are plastic wall anchors (dill hole, insert anchor, hope it grips when you tighten screw), black colored flush mount screws, and a small level that is about an inch in length so would suggest using a larger one to be sure. Overall I would not recommend mounting these panels edge to edge unless you have sufficient knowledge to insure they are aligned, secure, and able to support the load in advance. I say in advance since after the fact is going to be an expensive repair job. The storage holders that clip onto the track seem well made and there is a selection to choose from, but be aware that the wall load needs to be in line with what your mounting "job" load will support. If you decide to not mount them in a line then the 16" on center stud wall will help with this issue. I am giving them four stars since personal responsibility plays a roll in any project. The absence of the backing plate is really making this more of a three star product but priced so low (at time of review) to make it appealing for what it does provide. Just make sure more than one pair of screws is in a stud and it should make the 165lb per panel limit. Of course mounting in to another material like concrete or a spanning member between studs would be better.

great product and EASY to install.

Tek kelimeyle harika!

Overall I am impressed with how durable this storage set feels. It's all relatively thick gauge metal and feels like it will last quite a long time. I do like that it came with a few extra of the rubber friction pieces in case you wear any out or lose any. These are the black rubber pieces that friction-fit the bottom of the hangers onto the track.I mounted my set into a masonry block wall. I did not use the included screws/plastic anchors, and instead just used Tapcons. I put 6 into each section of track, but I think just 4 would have been plenty strong enough. As others have noted, the holes at the edge of each track are very close together between neighboring track sections. I would probably use 4 middle holes instead of using the outer holes if I were to mount this again. If you are mounting this on drywall or studs, it will likely be difficult to get 4 screws per section into studs. If you have an exposed stud cavity, it would be easy to add some blocking allowing for secure mounting; however if you are mounting onto a wall with drywall on it, you will likely need to use some drywall anchors.Do note, that unless you use the included screws (or screws with a flat top that countersinks into the mounts perfectly), the protruding screw head will interfere with the bottom part of the hangers. If you use Tapcons like I did, you will not be able to place a hanger in the same location at the screw (see photos). If you want to do this, you will need to drill or file out some of the bottom hanger lip to allow clearance over the screw head.