Lame per sega oscillante EZARC in titanio, standard e extra lunghe, perfette per tagliare metallo, legno, chiodi, viti e plastica. Confezione da 12.

Great

These EZARC Titanium Oscillating Saw Blades are some of the best I have used. Sharp, fit good and are long lasting. You can't go wrong with these in my opinion.

I'm always skeptical of anything that says coated with a special metal like titanium. However these blades have taken a beating and remain just as sharp as the first use. And the picture I've included you can see that the blade has gotten so hot that the paint has removed itself from the blade. But you can still feel the teeth even after going through nail after nail and even through rafter joint pads and some concrete.I was ready to swap out the blade, but compared it to a new one and realized the only issue with it was the missing paint because it had gotten so hot going between 2x4s to get to nails. There was literally no issue with the cutting edge after removing an entire truss.These blades definitely performed beyond my expectations and proved their durability.

Alles gut

There are 12 blades in total, 6 short ones and 6 long blades. It also comes with a small tool box to store the blades. Finally, it also comes with two adapters to fit specific tools, fortunately my oscillating tool did not require it. I selected these saw blades for my oscillating tool because I needed the extra-long blades that came with this order. A small camera I have fell inside a narrow space adjacent to my outdoor cabinets, so I had no way of reaching it without cutting a slot in the rear of the cabinet. However, the space I had to cut through the wood was between a concrete pillar and the cabinet itself which I did not want to cut through. As you can see from the pic, the blade cut through the wood. I'm not a craftsperson so I did not cut it with any precision or straight line. This area I cut is on the rear of the cabinet and not visible to anyone, I just need to make a cut out to remove the camera I dropped in there. The blade worked as advertised for my limited use.The product page also claims these blades can cut through metal, however I have yet to use it for that purpose. From my experience using other blades to cut through metal (nails, screws,) the tooth edge of the blade usually break or wear out quickly so I am looking forward to see how the EZARC blades do with metal. I will update my review when I do.