Prodotto di ottima qualità e funzionale.

De los 4 que compré uno venía defectuoso

Fanno un buon lavoro, funzionano molto bene e il prezzo è molto più conveniente di quelli della concorrenza

2 appareils commandés pour remplacer deux interrupteurs en va et vient dans une cave afin d'éviter les oublis de lumière allumée.Il n'y a pas de notice donc pas facile si on ne connait pas un minimum l'électricité.J'ai mis quelques photos pour aider.Les appareils fonctionnent bien. Ils ont l'air très solide.La détection est parfaite mais bien meilleure avec le châssis monté par dessus.J'ai aussi fait un montage avec un seul appareil et cela fonctionne parfaitement.Pour un va et vient il y a 3 fils. 1 phase et deux navettes. Il faut faire un montage deux fils. Bien repérer les câbles avec un multimètre.Je recommande ce matériel, livré bien protégé, rapidement et beaucoup moins cher qu'au Brico du coin. Merci.

A distanza di 11 mesi ha smesso di funzionare.Mi chiedo se sia coperto da garanzia.SalutiMassimiliano

Işık Hassasiyet ayarı iyi değil

It works as expected and allow easy access to the configuration buttons.

Firstly just to say I have been an electrical contractor for over 20 years (mostly industrial). I always give an honest review based on my experience.I have fitted literally thousands of Pir detectors over the years.This item was purchased as a straight replacement for one I have had on my landing for around 15 years.It recently gave up after many years of excellence service.I don't purchase the cheapest if I can help it so had a look around and thought this one looked ok. It was almost twice the price of some available but again I thought I'd rather have better quality.This item is twice the depth of my old unit. This is not really an issue for me as mine was fitted in an extra deep dry lining box.This will however be a major issue for a lot of people.The plastic front pops off revealing a very flimsy metal chassis which is screwed in to the back box. No screws were provided with mine (bit pathetic really) so I used the old screws. Even the slightest pressure tightening them up distorts the chassis out of shape. I ended up putting small washers it was so flimsy.Detection is ok I guess although probably only about 60% the coverage of my old unit.The adjustments for lux and time are quite effective and easy to use.It does seem to be smaller than a standard switch, I had to do a bit of caulking around the edges to get it to look ok.In summary. It works ok, not great range or coverage compared to a 15 year old unit it replaced.It is a little flimsy for my liking, a bit smaller than it should be & why supply it without screws ?Even the cheapest mass produced switches we fit in the industry come with standard screws.A very average unit.

Non è compatibile all’uso da me sperato. Non funziona e devo sostituirlo con altro modello.

Ottimo x accensione luce