CHC-V6 Hotend 24 V 50 W - Testina di stampa per 2.4 Prusa Extruder 3D

I got a max of about 15mm³/s of flow through it with PLA at 240°C before my extruder started skipping.It also really struggles to keep up with stronger part cooling fans. My Stealthburner Toolhead has fairly strong Sunon fans, and with the part cooling fan at full the hotend can't push past around 215°CThe biggest issue BY FAR was the thermistor cable. It's a neat super flexible sleeved cable, but basically impossible to strip conventionally. The only way to strip it if you are not happy with the pre-crimped connector is by very carefully cutting the sleeve with a sharp knife, and then pull it off without much force. Even then crimps have a tencency to fall out again because the wire consists of a series of weaved short thin strands that simply get pulled out if you pull on it, so you have to be extra careful when pulling out the connector. I've accidentally ripped out the wire from the crimp multiple times, even when I was already careful, and every time it actually rips off the end so you have to go through the whole stripping process again as the wire gets shorter and shorter...

worked well from 1st second. love to think about "250 degrees", turn around, turn back again and it's at 250 degrees. recommended heating the bed fully first if you have a no hipower one, before the hotend, otherwise it s gonna melt a lot of plastic thru the nozzle while waiting (and mess the prime line while stickin to the nozzle).