Descrizione pt100, arrivate pt1000. Male maleSi può risolvere cambiando la resistenza sul modulo ma chi te lo fa fare. La ordini apposta. Etichette riattaccate che confondono le idee. Roulette russa, non sai quello che ti capita

Board worked great first try. Used it for my 3d printer running klipper to use a pt100 sensor on the hotend. Plugged it into my RPI and everything worked (almost ) first try (had the wires switched around in the config) which is a first for me. If I’m being honest, I’ve had enough bad experience buying electronic parts on Amazon that I wouldn’t recommend it personally. Looking through these reviews a lot of people were sent pt1000 boards instead of pt100’s. This isn’t super uncommon when buying small electronics on Amazon. Def wouldn’t do it very often unless you’re in a pinch and need a pet asap like I did. Other than that, everything was great and I was sent a genuine adafruit part, which are always high quality. For those wondering btw, the 4301 resistor on the board (look closely for that number) is for a pt1000 and the 431 is pt100. If yours says 4301, it’s the wrong part.

I thought it was DOA but after I bought another one from another firm for less to make sure it was bad, I noticed my mistake in wiring it and it works fine. Mine was PT100 as expected.

Fonctionne bien mais prix élevé

Worked completely fine with PT100 sensor. Easy installation and run by Arduino. Also was delivered fast.

Took me a while to figure this out, hopefully it will help someone else. This is actually a pt1000. I thought it was a fluke so I ordered another and got another pt1000. Peel the pt100 label off the package and you will see the pt1000 branded on the bag

Scheda assemblata bene e funzionante. Costosetta...