2 set da 24 V 48 W, termistore per riscaldamento in ceramica con morsetti di fissaggio serie P1 compatibile con Bambulab P1P P1S P1S Combo stampante 3D

worked like a charm well pleased

Not much to say. It's a good thermistor, I applied it to my P1S while swapping nozzles after a print disaster, and it is running prints like nothing happened.

Purchased these to fit to the spare Bambu hotend that came with the machine and an aftermarket hardened. Worked fine at first but quickly started giving very inaccurate temperature readings. After a short time printing (not every print though), the temperature readings were so far off the hotend was cooling down and jamming up.First jam was with a silk PLA which was annoying to remove from the extruder, but as this was the only filament that seemed to have issues at first, I kept using the hotend with these sets installed. The real problem however was when it did the same running PETG-CF, a print which I had planned to leave overnight. It was removing the hotend after this jam that I realised that whilst the printer was reading 60 degrees, the hotend was barely warm to hold. It also seemed to get to temperature a lot quicker when starting this print which should have been an indication there was an issue.The price on these has also gone up from £16 to £19 since purchase, and per item, the genuine Bambu parts are now cheaper and less likely to cause potential damage to your machine.Maybe I got unlucky with a bad one, but when a bad thermistor could ruin the toolhead a printer that took a large bite from my student loan, I wouldn't recommend these as the risk isn't worth it. Especially when they can under-read and could cause a fire.

Not as good as the ones supplied by Bambu, but are useable in a pinch. Copper wires are very thin and have to be fortified with extra heat tape because too much of the copper wire is exposed when compared to the original Bambu thermistors.